Sewer Ejector Pumps
- Water Softener Installation and Repair
- Leaking Outside Faucet
- Main Water Line Installation and Repair
- Sewer Camera Inspection
- Water Filtration System Installation
- Sump Pump Installation and Repair
- Tankless Water Heaters Installation and Repair
- Water Heater Installation and Repair
- Bathroom Plumbing
- Piping and Repiping
- Pressure Regulator
- Reverse Osmosis System
- Sewer Ejector Pumps
- Sewer Line Repair and Replacement
- Leak Detection and Repair
- Kitchen Plumbing
- Hydro Jetting
- House Slab Water Leak Repair
- Gas Line Installation and Repair
- Backflow Preventers
- Drain Cleaning
- Toilet Repair and Replacement
Schedule Services for Sewer Ejector Pumps
If you have a bathroom, laundry room, or other plumbing fixtures located below the level of your main sewer line, a sewer ejector pump is essential. These pumps move wastewater upward so it can reach the main sewer or septic line, which relies on gravity to flow. Basements are the most common place we install these, but we also see them in additions or split-level homes.
Without a properly functioning ejector pump, waste water from lower-level fixtures can back up, causing damage and major cleanup headaches. If you’re finishing a basement or converting space into a rental unit or extra living area, this system is something to plan for early in the process.
Not every sewer ejector pump includes a grinder, but there are situations where having one makes a big difference. A grinder pump includes a macerator that chops up solids into finer pieces before sending them into the main line. This prevents clogs and makes it easier for the waste to move smoothly through long or narrow piping.
Grinder pumps are usually recommended when you’re dealing with higher usage, longer pipe runs, or sensitive plumbing systems. They’re also helpful when the wastewater includes more solids than average, such as in rental units or commercial applications. In standard home setups with limited use, a non-grinding ejector pump may be just fine.
We’ll always evaluate your setup and make a recommendation based on what gives you the most reliable performance for the long haul.
Like any mechanical system, ejector pumps require some attention to keep them working properly. The most common issues we see include float switch failures, clogs in the discharge line, and motor burnout. Sometimes the pump will run constantly or not turn on at all, both of which are signs that something isn’t right.
Routine maintenance is key. We recommend having the pump checked annually, especially if it’s being used regularly. Cleaning out the basin, testing the float, and inspecting the check valve are simple steps that can prevent big problems down the road. If your pump starts making unusual noises, smells bad, or stops keeping up with the waste flow, it’s time to call us.
Installing a sewer ejector pump involves more than just dropping a pump into a pit. We start by choosing the right location and digging a basin for the pump and its components. From there, we install the pump, venting, and discharge piping, and connect it to your existing plumbing system.
We also install a check valve to prevent backflow and ensure the electrical supply is properly wired and protected. Once everything is in place, we test the system under real conditions to make sure it operates as it should.
If you’re adding plumbing to a lower level or your existing ejector pump is acting up, Go With The Flo Plumbing can help with expert guidance and clean, reliable installation.
Expert Plumbing & Home Maintenance Services. Serving Fort Wayne and Surrounding Areas
- Angola
- Arcola
- Ashley
- Auburn
- Butler
- Churubusco
- Columbia City
- Corunna
- Fort Wayne
- Garrett
- Grabill
- Hamilton
- Huntertown
- Kendallville
- Laotto
- Leo-Cedarville
- New Haven
- Saint Joe
- Spencerville
- Waterloo